I was bored again.
Grabbed some used #400 mesh, x length of 2mm silica, x length of 0.5x0.1mm Kanthal A-1 ribbon.
I cut the mesh to x size and wrapped it around the silica, not too tight, just so that I can barely slide a new 2mm silica in there if I need to, pretty much so that the silica isn't there loose just snuggly in place..
Wrapped 3/2 turns of the ribbon, ended up with 1ohms according to Vamo. Driving it on a Smoktech 'The Natural'.
http://i.imgur.com/0M1VqO9.png
Works really well, as you can see the silica collects the juice from the bottom of the Phoenix Dome (Wyvern/Rainbow V3/etc) quite nice. Vapor really nice with 45/55 and flavor awesome as it always is with the coil on the side of the Dome right in front of the air hole.
Vape on!